I would be grateful if you could answer just one point. I would like to ask you about these three points. ・ If a command is sent to the web camera on teraterm, will any response be returned on teraterm? When sending a command on teraterm, can I just type the VISCA command as it is (eg 81 01 04 47 00 00 00 00 FF) HyperTerminal, or TeraTerm - or use the Send Printer Commands function in.

・ If it is VISCA standard, is the command common? (Since I examined it, it was recognized that it was the same because it was the same command on Sony and Cisco web camera) This web interface lets you view status information about the printer and. The web camera I purchased has no command table, only information that it uses the VISCA standard. (Port, baud rate, data bit, parity, stop bit are set) I'm thinking of using teraterm to check command control.Ĭurrently, teraterm is the stage where the web camera COM port is set and connected to the web camera. I'd like to do it, but I have a hard time without knowledge on the hardware side. Recently purchased a web camera and controlled the web camera via serial communication via Rs232c connection This is a method for controlling a camera using the VISCA SONY standard from a PC.

Teraterm script serial port